new banner.jpg (9737 bytes)

Telephone: (607) 589-6160                     Fax:   (607) 589-4026                     Email:   info@northeastimplement.com

                                                   

Northeast Implement Corporate Home Page

VALBY Wood Chipper

VALBY DOT Forestry Trailers

VALBY Traction Tire Chains

VALBY Log, Sorting and Demolition Grapples

VALBY Tractor Grapples

VALBY Log Grapple for Skidsteer

VALBY Skid Steer Wood Chipper

Forwarding Trailers & Loaders

FARMI Bio-Fuel Chippers

FARMI Forestry Winches

Electric Motor or Engine Driven Wood Chippers

PTO Shafts

Homepage

 

 

Hangers

The hanger enables the grapple to swing in two directions which reduces stress.

Finding a hanger for a given boom can be problematic, as there are many different widths, and hole dimentions used on booms on which a rotator is put.  For this reason, a half hanger can be a good solution.  A half hanger provides the portion of the hanger which connects to the rotator (as shown below).    The ears that connect to the boom should be fabricated and welded onto the half hanger, allowing the user to make "ears" which will fit their boom.

The width of the half hanger, as shown in the picture to the right, is correct for the R45 rotator.   The pin size is correct for the R3 as well.  If this hanger is to be used on a R3 Rotator, some method of "shimming" should be used to fill this extra space.

wpe2A.jpg (14537 bytes) wpe2C.jpg (16073 bytes)
A Half Hanger Above:  a Half Hanger as it sits on a rotator.  The base, and ears would be welded to this.

 

 

Here are examples of some hangers we stock.  Due to the many varied boom widths of machinery that use grapples and rotators, it is unlikely that you will find a hanger for your application "off of the shelf"  Your best bet will likely be to either fabricate a whole hanger, or using the half hanger as a base, fabricate the upper part of a half hanger. 

wpe3D.jpg (17427 bytes)

 

Hanger Model

For Rotator Model

 Rotator Opening (mm) Rotator Pin diam. Rotator to Hanger Pin Part # Boom End Width Boom Pin Diameter Loader End Pin #
32844623 FR10,GV4             R45, IVR4,59 75 mm 25 mm 52062270   61 ½ mm. 20 mm 52062262
33280025 FR07 , GV3           R3, IVR3, 59 62 mm 25 mm 43280445   75 mm 25 mm 43280445
23391709 FR1, IVR4.59          R45, GV4 75 mm 25 mm 43280445   75 mm 35 mm 43391713
Palfinger 1

R45, GV4

 76 mm 25 mm 71 mm 30 mm

A hanger enables the grapple to swing two ways.  Below are some examples of hangers.  The top end of the hanger is fastened to the loader's boom, and the bottom to the rotator. 

wpeAE.jpg (54102 bytes)

 

Send mail to info@northeastimplement.com with questions regarding our products, or call (607) 589-6160.  Including your name and address will help us to locate a dealer  near you.

Fax: (607) 589-4026.  Mail: 460 Halsey Valley Road, Spencer N.Y. 14883.